Hello,

New here so sorry if this is in the wrong spot.

I have a 2207 Haas SL-20A. I am having an issue boring. I am trying to machine 3.5" soft jaws and no matter what I do or how I set up the tool it is cutting to almost 4 inches. I can't tell if this is a programming issue or a machine issue or a machine issue. I seem to be able to cut O.D. just fine but when I go in with a boring bar it give me problems. I am using fusion 360 to program this with the generic haas turning post. Here is a copy of my code if that helps at all. Any help would be greatly appreciated.

O1005
N10 G98 G18
N11 G20
N12 G50 S3000
N13 G53 G0 X0.
N14 G53 G0 Z0.

(Profile Roughing1)
N15 T1111
N16 G99
N17 G97 S2000 M3
N18 G54
N19 G0 X1.0156 Z1.7422
N20 G50 S2000
N21 G96 S1601 M3
N22 G0 Z-0.0328
N23 G1 X3.5076 F0.004
N24 Z-0.0078
N25 X3.4276 Z0.0322
N26 G0 X1.0156
N27 Z-0.0578
N28 G1 X3.5076 F0.004
N29 Z-0.0328
N30 X3.4276 Z0.0072
N31 G0 X1.0156
N32 Z-0.0828
N33 G1 X3.5076 F0.004
N34 Z-0.0578
N35 X3.4276 Z-0.0178
N36 G0 X1.0156
N37 Z-0.0959
N38 G1 X3.5076 F0.004
N39 Z-0.0828
N40 X3.4276 Z-0.0428
N41 G0 X1.0156
N42 Z1.7422
N43 G97 S2000 M3

N44 G53 G0 X0.
N45 G53 G0 Z0.
N46 M30
%