[Danijel]

Hi,

Is it possible that on Makino machines the PMC is hidden?! I spoke with a Makino technician, and the answers was: just Makino Japan can download the PMC.

When I try to download it from the boot menu, under the "System Data Save" there's not! In the system menu, I can just see the status of X and Y.

Do somebody knows about that problem on Makino? there is really no way to have it? Even online with Fapt Ladder could be ok.


The machine is Makino V55 and I don't know the CNC model.


Thank you!

[greenery_fr]

Hi,

Is it possible that on Makino machines the PMC is hidden?! I spoke with a Makino technician, and the answers was: just Makino Japan can download the PMC.

When I try to download it from the boot menu, under the "System Data Save" there's not! In the system menu, I can just see the status of X and Y.

Do somebody knows about that problem on Makino? there is really no way to have it? Even online with Fapt Ladder could be ok.


The machine is Makino V55 and I don't know the CNC model.




Thank you!

Can you backup MMC to memory card

[jdeere4250]

listen boys, there is no pmc on a makino like this one ,. even the new ones only use pmc for the estop circuit .
If you are trying to save the equivalent of the pmc parameters. and if it is not in the manual I can email you a procedure for this.
The sequence is in the From of the machine tool CNC. Not battery backed up. and certainly not editable by the end user.

[Aaron liang]

Yeah,Very correct.
This machines no PMC ladder.May be programmed using VC.

[cncrepairs]

Hi

If ur machine is Pro 3 and u have the Prg backup, only run the prg O6666 all pmc data values get set .All the best pl confirm the result

cncrepairs
Pune India

[wingnut007]

listen boys, there is no pmc on a makino like this one ,. even the new ones only use pmc for the estop circuit .
If you are trying to save the equivalent of the pmc parameters. and if it is not in the manual I can email you a procedure for this.
The sequence is in the From of the machine tool CNC. Not battery backed up. and certainly not editable by the end user.

Not true. To access the ladder on Pro 5:

Start>programs>CNC Screen Display>System (hard key)>+>+>PMC Ladder

You CAN edit the ladder. I have done it.

[dinesh]

Not true. To access the ladder on Pro 5:

Start>programs>CNC Screen Display>System (hard key)>+>+>PMC Ladder

You CAN edit the ladder. I have done it.

I need procedure on Pro-3 to see the ladder and i dont want to edit ladder.
can some body help.
with regards
dinesh