Yep, it's the difference in the feed length that is throwing me off. I noticed that you are using a couple of subs, what's the feed length if you set NCPlot to ignore subs?
Scott
Yep, it's the difference in the feed length that is throwing me off. I noticed that you are using a couple of subs, what's the feed length if you set NCPlot to ignore subs?
Scott
Well with subs set to Ignore All it works 1 min 12 seconds just like you got.
Subs are these:
&HE:%
:0001
G01G40G97G98F400.
M98P10999
M99
%
&HE:%
:0002
N21G01G98Z0.500F400.
N22G40
N23G97
N24M98P10999
N25M01
N26M99
%
&HE:%
:0999
N1G01Z1.00T0000
N2M99
%
But since my mill uses subs sometimes does the ignore all stick for both
mill & lathe?