[kopsik]

Hello

So yet again I have a question regarding Mastercam. I have to cut angled slots and I am using 3d contour and very small depth cuts. The problem is that at first the tool cuts only a very little part of the toolpath - the corner- and then cuts air.

How do I make this operation faster?

I have attached a sketch.

[seijack]

Attach your file so we can check your settings.

[txcncman]

This is a case where I would either add my own geometry and/or make multiple operations and shorten the start of the contour for each operation appropriately.

[cnc-king]

use tool path trim feature to trim the toolpath so it gets rid of the air cuts and only cuts actual material