I've had my designing computer crash and trying to set up on a windows 7 unit. I've been using Mach 2 for 7 years but now I can't get the licence to stick. I've repeatedly pasted the licence dat file into the same folder as the mach 2 exe file but still get that I am in "Demo Mode". Any suggestions?
Thread: Back to the beginning.
Results 1 to 3 of 3
-
03-17-2011, 01:09 AM #1
Banned
- Join Date
- Mar 2011
- Posts
- 0
Back to the beginning.
-
03-17-2011, 01:17 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Send an email to [email protected] and ask them.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
03-17-2011, 01:55 AM #3
Banned
- Join Date
- Mar 2011
- Posts
- 0
Will try. Thanks for a prompt reply! LPE
Reply With QuoteSimilar Threads
-
Finding a beginning job?
By NullEntity in forum Community Club HouseReplies: 6Last Post: 03-04-2011, 06:05 AM -
Drip feeding fom the beginning
By alejorestrepo85 in forum Mazak, Mitsubishi, MazatrolReplies: 0Last Post: 06-04-2010, 05:33 PM -
Just When I Thought I Was Beginning to Grasp
By gerryv in forum Mach Software (ArtSoft software)Replies: 8Last Post: 12-09-2007, 01:04 AM -
N at the beginning of each tool?
By gearsoup in forum Post Processors for MCReplies: 9Last Post: 11-20-2007, 03:24 PM -
At the very beginning
By rackbox in forum DIY CNC Router Table MachinesReplies: 16Last Post: 12-01-2004, 11:56 PM
Posting Permissions
