David,
Really what you need are the parameter set from the Machine Builder..... all parameter tables are set by the Builder and are unique for each machine. Somebody elses paramter set would not help you.
If this is not available, you have to go through each parameter and enter in the appropriate value, you will also need to restore your PLC program. None of this terribly difficult and could be done by a Fagor Technician in just a few hours total..... I recommend you contact your local Fagor office to find where help is closest available. In Australia, I think the first place to contact is High Technology. Their contact information can be found at the below link:
Fagor Automation's commercial network
Hope this helps and good luck !
Todd