[MynamesKenny19]

Haha nope, I sure wish it was mine though! Nahh, it's a site I found while searching for "cnc taig lathe" online. Thanks for helping out though man, I appreciate it! I'll start a thread here when I have most of the parts I need for a conversion, that way it doesn't take ages. I have 2 nema 17Y4 motors but they have 110 oz/in of torque, I'm not sure if thats enough. I got them out of an old flatbed scanner I found at the junkyard, they still work too!

[Punisher_67]

Haha nope, I sure wish it was mine though! Nahh, it's a site I found while searching for "cnc taig lathe" online. Thanks for helping out though man, I appreciate it! I'll start a thread here when I have most of the parts I need for a conversion, that way it doesn't take ages. I have 2 nema 17Y4 motors but they have 110 oz/in of torque, I'm not sure if thats enough. I got them out of an old flatbed scanner I found at the junkyard, they still work too!

Kenny I think 110 oz/in should work good