is there no peck drilling in visualmill? I don't see it anywhere and a search of 'peck' in help doesn't show up with anything
is there no peck drilling in visualmill? I don't see it anywhere and a search of 'peck' in help doesn't show up with anything
I use VM6 Pro
I change my drilling type to "breakchip" for enough of a stutter to break the chip.
I change my drilling type to "deep hole" for a full retract at every peck interval.
I consider this to be more than adequate.
www.integratedmechanical.ca
Select - Holes under maching operation, then select drill, cut parameters. Under Drill types select deep.
Hope this helps, as I got stuck on this one also.
CNCMasters - Supera 4 axis
Can-Blast 2001 Inc.
North Bay, ON.