I need to get some panels made for a chassis for some electrical equipment I'm building. It's a DAC that I'm working on and I just need a front and rear panel. I'd like them made in 1/2" aluminum anodized black. It would have a recessed hole and a through hole and then some engraving. I can draw up the solidworks files and send them or what not I'm just wondering how much someone her might charge me to run them and for materials and what not? The engravings wouldn't have a fill would just be the bare aluminum underneath and the panels would be 12"x3" and 12.5"x3.5" 1 of each. Anything else you need to know I'm sure I can answer.