Hello,
I have almost completed my build for a small CNC moving table build on the Vectric website and thought maybe it would be good to post the thread here on the Zone also. I designed all my parts with VcarvePro and most of the larger parts were laser cut from HRS or aluminum.
I designed it all from scratch and even designed the motor coupler from flat stock, motor brackets from flat aluminum, and have a cable carrier that is made from ABS pipe that is working fine. I thought some of the ideas might help people getting ready to build and perhaps I might get some constructive criticism from other members that will enable making improvements where needed. The build is almost done so I am not sure how to post the thread up to this point, and any advise or suggestions is appreciated. I will post a shot of the end view showing most of the machine for reference.