Hi Guys,

Sorry for asking what is no doubt a very common question but I thought it would make it easier if I put all the info I needed in one place.

I have a Bridgeport Series 1 EZ Trak machine with Z Axis upgrade. The old control boards are getting long in the tooth and it doesn't always like to boot up. Based on that I figure it is time for an Upgrade to allow it to run off Mach 3 or similiar.

I say Mach 3 as that is what I have running the CNC Plasma.

So not knowing much about upgrading the Bridgeport to work with it I thought I would ask here.

After reading around I am gussing I just get the old control boards etc off and replace it with a controller setup of some sort which will then interface ??

Any info or links would be great.