yes, figured thats just for a guide, used it on g119 cause g111 was already used. could it make a difference?The program indicates that it is linked to G111 BUT then you stated that you have it linked to G119?
no i have not, what does x1.25 h1 do?Have you programmed the call to your sub-program as follows?
G119 X1.25 H1
Thread: mp10 xyz probe cycles
Results 1 to 20 of 22
Threaded View
-
11-30-2014, 08:53 AM #13
Registered
- Join Date
- Apr 2014
- Posts
- 44
Re: mp10 xyz probe cycles
Reply With QuoteSimilar Threads
-
Renishaw Mi12 MP10 Spindle Error Alarm
By imjustakid in forum Calibration / MeasurementReplies: 0Last Post: 03-05-2014, 09:26 PM -
lost Renishaw Probe Cycles for M2 Mitsubishi control on OKK MCV-800
By denny409 in forum OKKReplies: 0Last Post: 02-01-2014, 08:59 PM -
TP-100 Probe - Compare Performance Motion probe to IMService probe
By dgoddard in forum Digitizing and Laser DigitizingReplies: 3Last Post: 04-06-2013, 07:13 PM -
Renishaw MP10 on OSP7000M - probe often stops during gauging cycle
By Darek833 in forum OkumaReplies: 10Last Post: 07-22-2010, 03:21 PM -
About MP10 on Fanuc16i
By erking8011 in forum FanucReplies: 0Last Post: 06-18-2007, 06:14 AM
Tags for this Thread
Posting Permissions
