I am trying to drill holes on a dome face, I draw an arc, then project it to the face, and when I post it the holes are in the right location, but the depth is just what ever I type in eg:z-.06 for centerdrill, but all the depths should be slightly differant.Any help would be appriciated.
Thread: projecting drilled holes
Results 1 to 5 of 5
-
08-20-2007, 08:19 PM #1
Registered
- Join Date
- Aug 2007
- Posts
- 95
projecting drilled holes
-
08-20-2007, 08:20 PM #2
Registered
- Join Date
- Aug 2007
- Posts
- 95
by the way I am using version 9.1
-
08-22-2007, 06:53 AM #3
Registered
- Join Date
- Nov 2006
- Posts
- 367
Dpark,
send me your part.
[email protected]
www.cad2cam.blogspot.comwww.cad2cam.net
Programmer/ Certified Cam Instructor
-
08-22-2007, 05:07 PM #4
Registered
- Join Date
- May 2006
- Posts
- 132
make sure the points are on the surface and use incremental depth
-
08-25-2007, 04:17 AM #5
Registered
- Join Date
- Nov 2006
- Posts
- 45
It probably is what is posted above. You should be able to view your tool path in 3D and see where it is going. If it doesn't look right your parameters are probably off.
Good luck
JImmy
Reply With QuoteSimilar Threads
-
Trouble with projecting curves
By rlrhett in forum MadCAMReplies: 11Last Post: 03-03-2007, 01:33 PM -
Projecting lettering to a surface
By wudbutcher in forum MastercamReplies: 2Last Post: 12-03-2006, 08:11 PM -
Projecting Line, Autocad 2005
By Nmbmxer in forum AutodeskReplies: 2Last Post: 04-05-2006, 03:46 AM -
Drilled Holes
By jonbanquer in forum NCPlot G-Code editor / backplotterReplies: 6Last Post: 05-25-2005, 05:17 AM -
Projecting Surfaces
By infinti_bc in forum Rhino 3DReplies: 6Last Post: 04-13-2004, 06:26 PM
Posting Permissions
