I have taken off and cleaned every connection i possibly can from the motherboard. but when i turn it on, it is not going to home. The Y axis goes home, but the x doesnt move. Then so when it gets up to the top of the rails the y stays still and the x moves right and wont stop.

Ive been looking at the sensors on the motors and how they act when they get to home. i feel like my X-axis sensor constant thinks that is it at home. its cleared between the sensor as there was some soot. but this is the only thing i can think of. again not sure if im making sense but if there was something stuck in the x-axis sensor then it would constantly be trying to find its starting point, but because the sensoring isnt clearing it keep movning.

does this make sense? im going mad over this thing.

Thanks
GG