Is there any programs that will change gcode for one machine into gcode for another that doesnt have all the same commands?
Is there any programs that will change gcode for one machine into gcode for another that doesnt have all the same commands?
None that I'm aware of. Have you tried a google search? A lot of it will depend on what needs to be changed.
You could write a script (VBS) to read the original then change any codes you need via the REPLACE() function.
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
what Im trying to do is write programs with canned cycles that I can convert to code that my machine will understand.
Probably something theres not much of a need for but I dont have a cam for lathe stuff and I wanted to see if there was something like this so I could get a little break doing the programs manually.
If the changes aren't too significant, I'll see if I can come up with a quick script to help you out. Let me know what you're going "from" and what you're going "to", and I'll let you know.
'Rekd
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Take a look at KipwareXC ... www.kentechinc.com