587,708 active members*
3,223 visitors online*
Register for free
Login

Thread: Forgot Offset

Results 1 to 1 of 1
  1. 09-20-2012, 02:07 AM #1
    josiah47
    josiah47 is offline Registered
    Join Date
    Aug 2009
    Posts
    5

    Forgot Offset

    has any one had it that their controller forgets an offset for a tool. see picture
    Tool 6 X axis, setted it at the beginning and then while running notice X was off so went and looked at table and it was blank??

    Any clues?
    Attached Thumbnails Attached Thumbnails jan 4 forgot offset.JPG  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. OOPS...Forgot something
    By cutter100 in forum Vectric
    Replies: 0
    Last Post: 06-17-2012, 04:41 PM
  2. forgot
    By cob in forum Mastercam
    Replies: 7
    Last Post: 03-03-2012, 03:34 AM
  3. forgot the file
    By Stran in forum Mastercam
    Replies: 1
    Last Post: 12-04-2009, 05:56 AM
  4. Forgot how to set homing
    By IQChallenged in forum Machines running Mach Software
    Replies: 2
    Last Post: 12-15-2007, 07:15 PM
  5. I forgot how to use Mach3
    By jrslick22 in forum Mach Software (ArtSoft software)
    Replies: 3
    Last Post: 12-06-2007, 08:27 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules