Can this be used as a VFD control... no encoder feedback, Spindle Speed control? That is what I am asking... Maybe it cannot...
Results 1 to 20 of 61
Threaded View
-
08-25-2014, 03:20 PM #11
Registered
- Join Date
- Jul 2004
- Posts
- 240
Re: Looking for Testers for my new "Step2Linear" (Step/Dir to analog ) module
Robot & Machine Design - BLUECNC4, GreenCNC3, RedCNC2L, SilverCNC2; CNC Software!
www.truemachinedesign.com - - - - - - - - - - - - - www.truemachineautomation.com
Reply With QuoteSimilar Threads
-
LinuxCnc "Step Time" "Step Space" "Direction Hold" "Direction Setup" values??
By blau_schuh in forum Dmm TechnologyReplies: 5Last Post: 01-12-2014, 07:07 PM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM -
Servo processor "upgrade module" - looking for volonteers.
By H.O in forum UHU Servo ControllersReplies: 68Last Post: 03-27-2011, 04:28 PM -
Can someone explain "Full step", "Half step", "Quater step", etc. ???
By danmst3k in forum DIY CNC Router Table MachinesReplies: 4Last Post: 12-04-2008, 06:13 PM
Tags for this Thread
Posting Permissions
