I bought a laser from X700 hflaser.com china and install it in the instructions, but got the following problems if you can help.
aa
1. After putting the tube included a water pump and laser machine.
Power has a red key (test) after you repeatedly press tube began to glow (duct work), but after a few minutes down the key again and the tube is not lit!
2. laser machine using a card 6515. Installation is successful. The program is EasyCut 5.3. In all options recognized well. Maybe I do not understand how to put cutting. Draw a rectangle, give him a starting point and other settings for engraving, and give start - nothing happens. Against key (Laser) 50W box is closed. Box name (Machine) is inactive. How to use menu download (CFG).
3. Key test of the laser machine how it works. Nothing happens when I press it.
4. Key laser also does not provide any results.
5. The laser tube I could not get to shine in any way.
6. How to send a valid file for engraving (MOL)
Please provide an example step by step Easycut 5.3 to carve a rectanglevide
Plese provide pictures.
Thank you in advance for your cooperation.
my e-mail: [email protected]