I have this bridge saw with no controller. I have spare servo drives, motors and some stepper motors and drives.
Also I have AC Drives with gearbox motor. The AC Drive is Teco MA7200 with lot of features.
which I can use to drive the cutter head if possible. I think the gearbox was previous used with the saw.
I don't plan to use a computer to control this saw because is just one axis only forward and reverse direct.
What I like to have is the following:
1. Control the speed of the axis Forware and Reverse during cutting.
2. Jog to position with different speed.
3. Automatic home position when it hit the right limit switch.
What is the best solution for this requirement.