I am trying to do a table probe calibration. before i do probe calibration. I have everything setup and when i try to mdi the calibration it goes up and doesn't touch of on the probe. does anyone have any idea what the issue is??
I am trying to do a table probe calibration. before i do probe calibration. I have everything setup and when i try to mdi the calibration it goes up and doesn't touch of on the probe. does anyone have any idea what the issue is??
See this video for good overview on how to calibrate probe:
Also, make sure you calibrate probe tip so it runs true otherwise your measurements with the probe will be off.
That video is on a next gen control. If you have an older Haas it won't work. Check your batteries on both tool presetter and spindle probe. Search youtube for haas automation probe troubleshooting.
This manual should help you out better.
Good luck!