yes sir! 4K fiber laser.
Adam
yes sir! 4K fiber laser.
Adam
Clean DXF for this design which has been already done by my diy machine.
4.0 mm sheet metal - 410x1500 mm
Any body have the USMC globe and anchor in DXF format for laser cutting?
Thanks Adam
here is one I have but connot upload it due to the size I tried to reduce it but still to large 700K boooo.
PM me with a email address and I will send it to you.
have fun
tom
there's one at my forum - marines logo free dxf
Attachment 229974
www.signtorch.com
Any style would be helpful.
Thanks
Ken
Can somebody clean up this file? it has too many small breaks in it.
Thanks in Advance!
i dont see the file
Rooster looks good here. No breaks, anyways.
Any assembly instructions available? Tnx!
I probably don't understand, but do you see the same as this:
Here is something I found this part was drawn twice on top of itself and don’t know if there are more like that. Sheetcam states there is overlapping lines as one problem. To find problems I used the contours tool to change the layer to another then un-check that layer as I go along. This removes it from the operation to see if that is what is causing the problem. If redoing the operation and it does not show the problem then you know where it is.
I removed the single dots in the image shown by urbnsr but that did not help it could be due to other problems in the drawing.
There may be too many to find.