Hello I am again,
While working at 5 phase microstepping, finally my 2 phase bipolar driver has been finished.
There is some feature about my driver :
- half and full step mode
- up to 3 A / phase-- I use parallel of L298
- current limiter : on steady, the current has limited to 1 A, so L298 is safe.
- Unipolar can use this driver, with some modification wiring.
This board is same as board that i used in 5 phase driver. but I change the position PIN of INHIBIT of L298.
So enjoy this driver in here :
MOTOR STEPPER DRIVER 2 FASA BIPOLAR (Cikotok 1.5