Hey Everyone I'm in need of desperate help here. I'm very new to CNC lathes I have ran mills my whole career. We recently have purchased a used Okuma Crown with the U10L control I have been able to navigate around the machine relatively easy but when it comes to putting in the program i have had a bit of trouble. I used Fusion 360 to make a simple turn two diameters to get used to the machine I used the Okuma Lathe post and it generated the program after getting the program into the actual machine I have had errors most which have been an easy fix but i have one line that keeps sending an alarm.The alarm is( Alarm 2366 Tool Radius Comp. No spec) the code line that this happens on reads (G90 G18 G3 x2.4992 z-1.5264 k-0.0312).Can anyone help me with this also if anyone has a sample program that they would share with me that runs on the U10L control so I can compare it to what I have to see where I am off. Like I said i am very new to the CNC lathe so any help with this is appreciated .
Thanks
What did you adjust on that line of code in the end?
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.