I am programming my parts with V24. Everything looks fine in the CAM Tree, I am using the "Bridgeport_DX-32_VMC_Rev1" mill post from the BobCAD website like I have been since I installed the software, and it looks fine in the Predator simulator. But when I run it in the machine it goes crazy. Mainly when doing interpolations. It should be machining a small radius on a corner in the X/Z plane, instead it is performing a large sweeping arcs in the X/Y plane. I posted it to a different machine (EZTrak) with the post processor for that machine and it runs fine. Thought it may be the machine, but on other machine, no problem. Then I ran it in V21 simulation and it performs the same erratic moves that it does on the Torq-cut. I deleted the post processor and re-installed and no change. It has something to do with the post processor I think. Any thoughts? I have attached the g-code txt file created from the Bridgeport_DX-32_VMC_Rev1 post processor.