[Bishbash25]

Hello i have just started using Tnc 410 and 426 heidenhain control conversational not g codes but i have a post processor for the 360 control using camworks.

I did try putting a program using the 360 post proccessor into the tnc 426 control which i mainly use but it was giving out errors in the CC (Circle Centre's)
of the program and tool compensation paths also showing word "errors" in the program on the CC lines of it.

Has anyone got the post proceesor to work for camworks for 426 control or point me to something i can try editing the 360 proccesoor or if i give you it to edit for me to work for 426 control would help me alot.

Thanks

Bishbash25

[Lars]

Hi Bishbash25
There is a Heidenhain 426 through the Universal Post Generator, but if I was you I would contact my local CAMWorks reseller first.

Best regards,
Lars

[Bishbash25]

universal post generator i have not got it on my laptop were can i get it?

Thanks

Bishbash25

[Bishbash25]

Ok just seen its on the camworks disk standalone program is this what i use to edit for all controls i use ?

Bishbash25

[Lars]

Hi Bishbash25,
Sort of plus some more.
There is a "getting started guide" under help in the UPG that will get you started.

Best regards,
Lars