Surface grinding means nothing if the parts are warped and the magnetic chuck sucks them flat. As soon as the magnet is turned off, the warp comes right back. The parts need to be shimmed when grinding so the warp is ground out. Using sand paper and a surface plate keeps the parts relaxed so the sanding removes the warp.
i got drunk and dropped 400 at the stupid casino. think i would know better since i work at one. . . 400 bucks could of gone towards a lathe or a bandsaw, etc.
i am so mad at myself! i prob coulda got my servos and cotroller instead of giving it to the damn casino. , . . arg
Sent from my GT-P1000 using Tapatalk
1-800-GAMBLER.....
Well that sucks! Drinking - Casino. Not both at the same time.
You would have spent the same amount of money on drinks alone in Norway!
actually i need to call 1-800-{gambler/beer/plasma tv/electronics/computers/tools/wife/dog/stsudent loans/ham radio/mortgage/gas tank/f150}
Sent from my GT-P1000 using Tapatalk
So gopher, what'd the machine shop say?
Sorry guys. Didn't make it to the machine shop. Things at work kinda slowed down. I will get to it
But I do have something else on my kitchen table now. Seriously, kitchen table
Aluminum cylinder and aluminum piston.
What to do? I have read that you should never hone an aluminum cylinder wall. . . Ideas?
Sent from my A500 using Tapatalk
It is nikasil plated , You can have it replated or sleeved (Steel).
Example only not a recommendation :
Cylinder Repair, Head Repair, Cylinder Replating Services by Millennium Technologies
Robert