587,760 active members*
2,740 visitors online*
Register for free
Login

Thread: exhaust system for small garage w/laser cutter

Results 1 to 12 of 12

Threaded View

  1. 04-03-2011, 09:33 PM #7
    shatterjack
    shatterjack is offline Registered
    Join Date
    Mar 2011
    Posts
    0
    I'm trying to understand whether it would make any difference in the system if I had the vac pump directly after the cutting table, or after the filter. I made a little sketch to show the two setups. Also if I'm going to add a second vac pump to the system, what would be the best place to put it in to maintain suction on the table material and air flow through the air filter?
    Attached Thumbnails Attached Thumbnails vent setup.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Small laser cutter for few mils mylar only.
    By Otatiaro in forum Laser Engraving / Cutting Machine General Topics
    Replies: 6
    Last Post: 03-17-2011, 05:44 AM
  2. Help with garage ventilation system needed
    By Rich05 in forum Uncategorised MetalWorking Machines
    Replies: 10
    Last Post: 02-28-2011, 03:19 PM
  3. Laser Cutter Exhaust Fan Booster
    By abbtech in forum Laser Engraving / Cutting Machine General Topics
    Replies: 9
    Last Post: 09-20-2010, 12:07 AM
  4. Advice Wanted buying a small laser cutter
    By Jolijar in forum Laser Engraving / Cutting Machine General Topics
    Replies: 4
    Last Post: 08-17-2009, 03:34 PM
  5. Small/Garage shops and the old Bridgeport.
    By katiebo in forum Uncategorised MetalWorking Machines
    Replies: 8
    Last Post: 03-13-2008, 02:56 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules