Perhaps this will guide you. THe machine needs to be turned on in a special manner to get to the FAPT side of things. If you see the CNC side, you're not there.
Results 1 to 3 of 3
Threaded View
-
03-16-2011, 05:08 PM #2
Registered
- Join Date
- Feb 2008
- Posts
- 586
Reply With QuoteSimilar Threads
-
Fanuc system 9 loading "hang"
By waterfall in forum FanucReplies: 19Last Post: 07-26-2017, 02:03 PM -
DX32 "Mentor's" [Creating Programs]
By minton in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 03-04-2009, 05:55 AM -
Continue subprogram after push "CYCLE-STOP"
By dzga in forum FanucReplies: 2Last Post: 06-13-2008, 11:18 AM -
Problem loading programs into DX32 control
By D.Blair in forum Bridgeport / Hardinge MillsReplies: 1Last Post: 03-05-2008, 03:32 AM
Posting Permissions
