Hi all; I need to tumble a lot of 2" x 3" x .125" up to 8" x 8" x .125" aluminum parts to a nice matte finish. I've heard two recommendations:
C & M Topline's 3 cubic foot machine:
Vibratory Finishing Machines | Vibratory Deburring Machines
and the 2.5 cubic foot PV machine from here:
PV Series Tumbler - MFI
There is about $1200 difference but the PV machine is supposedly much higher quality and far quieter. I'd love any advice on this as it's going to break the bank to get either machine and I don't want to waste any money I can avoid. Thanks!
-Mike