587,081 active members*
2,680 visitors online*
Register for free
Login

Thread: Spindle does not stop

Results 1 to 2 of 2
  1. 02-02-2011, 06:03 PM #1
    hydrospin01
    hydrospin01 is offline Registered
    Join Date
    Nov 2006
    Posts
    51

    Spindle does not stop

    Hey everyone, I have a colchester clausing storm 300 lathe, when commanded to stop the spindle takes about a minute to wind down to a complete stop compared to the couple seconds it use to take. M05, M30, M00, E-stop, Reset tried them all, same result. Anyone ever have this issue?
    Reply With Quote Reply With Quote
  2. 02-03-2011, 06:19 AM #2
    bigmousepusher
    bigmousepusher is offline Registered
    Join Date
    Apr 2009
    Posts
    24
    If you have a manual on the perameters there should be a perameter for startup and slow down time.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Need help with M05. spindle does not stop
    By jessebpm in forum Hyundai Kia
    Replies: 4
    Last Post: 06-03-2013, 09:45 PM
  2. e stop and spindle (on/off)
    By Zygoat in forum LinuxCNC (formerly EMC2)
    Replies: 3
    Last Post: 03-10-2010, 04:43 AM
  3. spindle won't stop
    By HBFixedGear in forum Fadal
    Replies: 4
    Last Post: 07-07-2009, 10:30 PM
  4. How can I stop the spindle ?
    By tmead in forum Mach Wizards, Macros, & Addons
    Replies: 6
    Last Post: 04-01-2009, 04:50 AM
  5. VMC-15: Spindle Would Not Stop !
    By StormWerkz in forum Fadal
    Replies: 8
    Last Post: 04-25-2007, 05:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules