[urbanimports02]

update. i just went back out and tried messing a bit more and changed some of the spindle control numbers in the motor tuning config, spindle axis, and it got better, so i kept adjusting until my hand held meter read pretty close to all the different S numbers i kept throwing at it, so i feel a bit better. i went into motor tuning, spindle axis, and changed steps to 1000, and velocity to 700, and it seems to work. that doesnt jive with anything i have read, so i think the pulley settings and min and max speeds need to be set. i would still like to know what settings anyone may have under ports and pins, spindle. and also under motor tuning, spindle axis. thanks

[kvom]

Jesse,

I posted on the other thread, but should done so here.

Are you using the motherboard upgrade in the CD-100, or your own PC? I am about to order a NM-200 with the CD-100 upgrade, and would like to assume that my machine will be properly configured and tested before it it shipped.

Thanks for any information.