AC or DC depends on the servo motor. AC motors and the electronics to drive them are much more expensive. My motors just happen to run at 120VDC. You can get servo motors in a wide variety of voltages.
Thread: Control Cabinet almost finished.
Results 1 to 7 of 7
Hybrid View
-
03-15-2005, 11:02 PM #1
Registered
- Join Date
- Feb 2005
- Posts
- 35
Reply With QuoteSimilar Threads
-
G-Code to DXF
By WayneHill in forum OpenSource SoftwareReplies: 227Last Post: 05-19-2021, 11:26 PM -
Visual Basic Controller Project
By dwwright in forum Visual BasicReplies: 30Last Post: 04-16-2016, 10:31 AM -
Stepper control software suggestions
By jlawren6 in forum Uncategorised CAM DiscussionReplies: 6Last Post: 05-21-2011, 11:42 AM -
CNC Glossary
By cncadmin in forum Community Club HouseReplies: 17Last Post: 03-09-2008, 09:08 PM -
How do you like my control cabinet?
By ESjaavik in forum Community Club HouseReplies: 8Last Post: 06-11-2004, 07:23 AM
Posting Permissions
