Dab,
Thanks for the link. I look at these and they won't handle 35,000 rpm or 2000 psi coolant. Also the taper on this Okuma is a HSK 63F. It had a 25000 rpm rotary that wouldn't handle the high rpm.
Again thanks,
camme
Dab,
Thanks for the link. I look at these and they won't handle 35,000 rpm or 2000 psi coolant. Also the taper on this Okuma is a HSK 63F. It had a 25000 rpm rotary that wouldn't handle the high rpm.
Again thanks,
camme
Scott bob,
The coolant is expelled thru an ER16 collet or the tool tip and at 2000 psi has no problem putting 8 gpm in the cut zone.
Thanks for your reply,
camme