Hey Todd,
You're amazing, you got my Fagor to accept the code psychically! But really, I tried it again just before I went to work this morning and it accepted the M03 code. So tonight I will enter all the M-codes. i don't know what I was doing wrong all week but it worked this time.
However, after it took the M-code, I got a error 108, leadscrew compensation error. when I checked the leadscrew compensation table there was a checksum error there also. I will try to reenter those tonight as well. even though there are numbers already entered. anyything special I should know about that?
Tinmuk
*********************
Any problem can be solved by the proper application of heat!