587,608 active members*
3,409 visitors online*
Register for free
Login

Thread: Losing Steps?

Results 1 to 4 of 4

Hybrid View

  1. 07-15-2009, 05:05 PM #1
    dmmcnc
    dmmcnc is offline Registered
    Join Date
    May 2009
    Posts
    14
    why not try low cost closed loop AC servo with high resolution absolute
    encoder, from www.dmm-tech.com

    HL
    Reply With Quote Reply With Quote
  2. 07-16-2009, 12:21 AM #2
    CarveOne
    CarveOne is offline Member
    Join Date
    Apr 2007
    Posts
    8082
    I'm with pminmo on this one. It sounds like you need to cinch down the coupler screws really tight, especially if they are Delrin or other type of plastic. Plastic will cold flow under a lot of pressure from the screws. It may take a while, but it will eventually happen.

    CarveOne
    CarveOne
    http://www.carveonecncwoodcraft.com
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Losing steps?? How do I know??
    By JeLC in forum DIY CNC Router Table Machines
    Replies: 28
    Last Post: 09-09-2009, 12:26 PM
  2. Im LOSING steps?!
    By Starleper1 in forum Benchtop Machines
    Replies: 4
    Last Post: 07-03-2009, 02:59 AM
  3. Help with CNC losing steps
    By Scramjet in forum DIY CNC Router Table Machines
    Replies: 6
    Last Post: 01-30-2008, 01:24 AM
  4. Losing steps - WHAT IS UP?!?
    By Sporqster in forum DIY CNC Router Table Machines
    Replies: 10
    Last Post: 04-27-2006, 03:50 PM
  5. Cause For Losing Steps?
    By FLUTE HEAD in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 7
    Last Post: 06-14-2005, 01:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules