[Fiddlemaker5224]

This was posted in another forum. I was just woundering if this was a good deal? I am not sure of the spec's. The research price is much higher the the asking price. Some guidance would be greatly accepted.

http://woodworkerszone.com/igits/showthread.php?t=6721

Thanks

[SPEEDRE]

Fiddle man. I have the same stuff. Bought mine when they first appeared on market. I have found them quite useful and profitable. They are paid for many times over. Good luck and welcome

[Fiddlemaker5224]

Thanks

Carl

[MIDDEN300]

i just bought a 2514 with 5 inch z frame only
does anyone know if the k2 2514 that comes with motors and controllers
complete is using servo motors and controller or was that a mis print,i have been doing a lot of research and what i see so far is i should use a
stepper system.also does every see the same problem with the gantry
flexing about a inch measured at motor.

any input would be appreciated

thanks
midden1

[Fiddlemaker5224]

i just bought a 2514 with 5 inch z frame only
does anyone know if the k2 2514 that comes with motors and controllers
complete is using servo motors and controller or was that a mis print,i have been doing a lot of research and what i see so far is i should use a
stepper system.also does every see the same problem with the gantry
flexing about a inch measured at motor.

any input would be appreciated

thanks
midden1

If you go to the K2cnc site you will be able to see the different options for the unit. You can add or remove what you want or don't want.