Originally Posted by
CAMFUN
Dear friend, I wrote a very good post for Mastercam, and I willl stay glad to share with you.My post do all drill cycles in command, helical circular interpolation, and arcs in all planes: XY/YZ/XZ.
I have tested this post extremely, so, I ensure for you that it´s a excellent post for heidenhain 426/430 systems.
If you want test, I´m putting in attach with this message.
The only problem is that was wrote for V9. I start in V8, but make some changes for V9.
Hope that helps.
If works for you, let me know.If not, let me know too.Maybe I can help you with the problem.
Read the header for additional notes, about the resources included in post.
Any doubt, contact me.If necessary, I do the changes for the post to V8 again.
Regards
Daniel