bowlingmac,
You wrote "CAMSOFT, I HAVE 2 WIRES COMING FROM DRIVE LABELED "X AXIS SIG" AND "X AXIS COM", WHICH I HAVE CONNECTED SIG TO MOCMDX, AND COM TO GRD. I BELIEVE THIS TO BE RIGHT."
Yes, these looks like the right ones. If they are labeled as 10 volts than these are them. Perhaps some one can confirm this.
Tech Support
CamSoft Corp.
[email protected]
PH 951-674-8100
Fax 951-674-3110
www.cnccontrols.com
Results 1 to 20 of 45
Hybrid View
-
06-10-2008, 01:28 AM #1
Registered
- Join Date
- Apr 2003
- Posts
- 332
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
Retrofit Anilam Control
By buff324 in forum Controller & Computer SolutionsReplies: 3Last Post: 04-29-2008, 12:22 PM -
Anilam Crusader II - Crusader 2 Training DVDs
By Mike Mattera in forum News AnnouncementsReplies: 2Last Post: 07-09-2007, 03:31 AM -
CamSoft Bridgeport Boss 4 retrofit
By kz1000 in forum CamSoft ProductsReplies: 4Last Post: 06-14-2007, 11:22 AM -
Anilam Crusader M DNC
By hsmcnc in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 02-20-2007, 11:06 PM -
Weight of BP Series 1 W/ Anilam Retrofit ?
By CNC OT in forum Bridgeport / Hardinge MillsReplies: 1Last Post: 02-17-2007, 03:13 AM
Posting Permissions
