does anyone have a good document that explains in detail how to use these commands on a lathe..I use turbocnc
does anyone have a good document that explains in detail how to use these commands on a lathe..I use turbocnc
Andy
Do you have Machinery's Handbook? http://www.industrialpress.com/en/Ma...k/default.aspx
You can get it for about $80 at Barnes and Noble. It has a section on G-code. Did some searches but couldn't really find a good guide.
If you're just starting with machining you really need this book.
Wayne Hill
Software For Metalworking
http://closetolerancesoftware.com