587,174 active members*
3,939 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Displaying PMC ladder in DGNS Page

Thread: Displaying PMC ladder in DGNS Page

Results 1 to 3 of 3
  1. 02-14-2008, 01:58 PM #1
    dinesh
    dinesh is offline Registered
    Join Date
    Jun 2006
    Posts
    31

    Displaying PMC ladder in DGNS Page

    Gentle men,
    I have fanuc OM-C system(M/C THK GRINDING). I am getting "Not ready" alarm.There is no manual for this.Also with DGNS page PMC ladder not displaying. I would like to know is threre any parameter for PMC Display in DGNS page. Thank you in advance for your help
    Best regards
    Dinesh
    Reply With Quote Reply With Quote
  2. 02-14-2008, 05:31 PM #2
    viorel26
    viorel26 is offline Registered
    Send a message via Yahoo to viorel26
    Join Date
    Jun 2007
    Posts
    119

    Param. 60 #2

    Param. 60 bit #2 = Dynamic ladder display is not executed (0) / is executed (1)
    Check the emergency stop buton.
    Reply With Quote Reply With Quote
  3. 02-15-2008, 01:16 PM #3
    dinesh
    dinesh is offline Registered
    Join Date
    Jun 2006
    Posts
    31
    Hi Viorel,
    I tried 60 bit# 2, but PMC is not displaying.And same bit is working with other machine on which pmc is already is displayed (tried 60#2 0/1).Is there any other option.
    Thank you for your reply
    With best regards
    dinesh
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. PMC-LADDER
    By CHANDRU in forum Fanuc
    Replies: 2
    Last Post: 12-14-2007, 04:17 AM
  2. Displaying Cycle Timers while running?
    By donl517 in forum Fadal
    Replies: 5
    Last Post: 10-01-2007, 04:12 PM
  3. DRO's displaying double
    By Metal_twister in forum Machines running Mach Software
    Replies: 11
    Last Post: 01-08-2007, 09:55 PM
  4. Arrow, Page Up & Page Down Keys - Rhino Video Tutorial
    By Robert Schutz in forum Rhino 3D
    Replies: 0
    Last Post: 04-25-2006, 04:09 PM
  5. NC reading tool length from offset page, not data page..?
    By RMagnusson in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 03-21-2006, 11:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules