No, what Geof is saying is that when the comp is turned off with G40, the tool is not far enough clear of the part.
No, what Geof is saying is that when the comp is turned off with G40, the tool is not far enough clear of the part.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)