Agreed on keeping on them about fixing your post. If you bought it, they need to make it run they way you want it to run, NOT what they think is best.
This was one of my bigger complaints when I was using Gibbs/Virtual Gibbs and GibbsNC/CAD/CAM over the past 10 years or so. I much prefer having complete control myself out of the box without having to buy 2nd or 3rd party products.
'Rekd
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)