[PETE1968]

i'm using the okuma post for the osp 7000 updated fron ver 9 to x
when i try and post a thread op (longhand or canned) it puts the start of file info at the end. does anyone no what would cause this. the post worked right out of the box except for this and some other minor changes.









N100 X4.35 Z.2359
N110 G71 X4.0966 Z-1.65 A30 H.1534 D.024 U0. F.125 M32 M75
$MACHINE_GROUP_1.MIN%
NAT01
( TOOL - 1 OFFSET - 1 )
( THREAD O.D. INSERT - TOP NOTCH THREADER )
N120 G0 G40 X20. Z10.
N130 G97 T0101 S150 M41 M4 M8
N140 G0 X4.35 Z.2359
N150 M9 G97 S800
N160 G0 X20. Z10. T0100
N170 M05 M02
%

[Steve Arteman]

I remember someting about fastmode on will cause canned cycles to do strange output sometimes. To check go to settings, machine definition manager, when in here at the top there is an icon that will say control def. open that in the area look for nc output in here look for post debug information and a box that says enable. make sure this is off no check mark if it is not on I would have to see the post. sometime it may be missing a $ somewhere.
Hope this helps
Steve
www.cad2cam.net

[PETE1968]

steve that did not seem to work

[Steve Arteman]

Pete,
Send me your Post I can take a quick look.
www.cad2cam.net