I have to m/c appox. 50 small slots with a .010 taper on the sides the slots are only .065 to .085 wide and .250 long. Any ideas on the best way to m/c these .We have thougth of may be sparking or wire cutting ? Any other ideas would be good
I have to m/c appox. 50 small slots with a .010 taper on the sides the slots are only .065 to .085 wide and .250 long. Any ideas on the best way to m/c these .We have thougth of may be sparking or wire cutting ? Any other ideas would be good
I forgot to say the mat. is s/s304 and .186 thick
individual who perceives a solution and is willing to take command. Very often, that individual is crazy.
Depending on how long the slots are Wire EDM is the best way to do this. 304SS will work harden if an end mill dulls too much in the cut. If it is short you could have these Laser cut too.
Good luck with what you decide.
Cheers!!!!!!!!
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com