I use G320 and Mach3 to turn my servo.
My servo turns CW perfect but when I try CCW G320 fails.
I tried to reverse encoder and motor power leads. Nothing changed. Again motor turns CW perfect but can not turn CCW.
My direction signal is correct. when I reverse encoder and motor leads I have to press negative X jog button to turn motor CW. Before changing leads I have to press positive X jog button.
Is there anyone who has experience about motors turning only one direction:withstupi
Results 1 to 2 of 2
-
03-04-2007, 09:07 PM #1
Registered
- Join Date
- Feb 2004
- Posts
- 77
G320 make my servo turn only one way
-
03-05-2007, 08:35 PM #2
Registered
- Join Date
- Feb 2004
- Posts
- 77
Today I disconnected all wires and reconnect them with fresh mind. Now my motor turns perfect.
Thanks for reading. Sorry for taking your time
Reply With QuoteSimilar Threads
-
Problem with servo controller (G320)
By faststeve in forum Gecko DrivesReplies: 19Last Post: 04-04-2007, 02:18 AM -
Some servo help and questions about the G320/340
By Eson in forum Gecko DrivesReplies: 0Last Post: 02-07-2007, 10:01 PM -
g320 48v servo will this work
By dgalaxy in forum Gecko DrivesReplies: 0Last Post: 05-30-2006, 02:10 AM -
G320 Fault light doesn't turn off
By lamote in forum Gecko DrivesReplies: 0Last Post: 04-11-2005, 10:39 AM -
G320 and back-EMF from servo
By rc-cellar in forum Gecko DrivesReplies: 5Last Post: 02-18-2005, 04:15 AM
Posting Permissions
