Re: Simple G-code question
That makes no sense. After the Z move is complete, it should just stay there until commanded to move again.
M5
G53 Z0
G0 X0 Y120 What happens if you run the code without this line? I understand the X and Y would not move, but what is the Z doing? Is the Z drifting down from vibration, or is it really being commanded to move? Try jogging X and Y to position after the G53 Z0 move and see what happens.
Try running this code and see what happens
M5
G53 Z0
G54
G0 X0 Y120
or this code
M5
G53 Z0
G53 X0 Y120
Jim Dawson
Sandy, Oregon, USA