Originally Posted by
Codythecreator
Has anybody out there had any success using the soyanpower svd-ps vfd for their spindle control? I’ve been struggling with getting mine programmed to work with Mach4 and would like to see if I’m overthinking it, or if it really needs as many parameters set as I’m thinking it does? Since it’s a Chinese vfd, there is a little bit of chinglish going on in the manual, although they did pretty good on it, but I can’t figure out if the “pulse settings” is the same as setting it up to be commanded by pwm, which is what the controller is using or if it is meaning something different. Things of that nature. Is there a generic, run of the mill, set of parameters that need to be set in order for it to work? I understand every vfd and system is different, and will have different parameters and what not, but I’m sure for the most part, a lot of them have to have pretty similar changes in order to to be programmed to work with a cnc