Re: Really need help with Camsoft CNC Controller
It sounds like you have the machine sort of working, but need to get the laser under control.
I would start by figuring out which Galil output fires the laser. The using the Galil Tools terminal (assuming a Win7 or later OS) issue a SB(output bit) to turn it on, or a CB (output bit) to turn it off. That will tell you if the hardware is working.
If the hardware is working, then it just a matter of getting the setup correct.
I don't know what G code command(s) is supposed to control the laser on/off. You'll need to look in the G code to figure that out.
If you don't have Galil Tools you can download it from the Galil Motion Control website for free. (registration required, but they won't spam you)
Jim Dawson
Sandy, Oregon, USA