Definitely capable of detailed carvings. I've done brass and wood carvings. This is a sculpt I made in zbrush and carved using my 4th axis. I upgraded to an actual spindle from them last week and from the stuff I've run since, it's going to be even better.
This was pulled into fusion and dine in an indexing setup before I had full fourth capabilities in it. Rotary itself cannot do this because it cuts from a zero location on the y the whole time. Vectric is a waste of you plan on doing rotary and want fourth axis. It unwraps only.
I've also done other carvings of signs that are on the 2.5d side.
Sent from my SM-N960U using Tapatalk