For 3/4” plywood you want to use a 7/8 or 1” long bit correct?
Or does a typical 3/4” spiral up or down cut bit have enough edge for cutting and chip clearing?
Results 1 to 20 of 290
Hybrid View
-
06-28-2020, 10:54 PM #1
- Join Date
- Feb 2019
- Posts
- 114
Re: Router Bits and EndMills: Pictures, Descriptions, and Uses
Reply With QuoteSimilar Threads
-
Router bits and Endmills guide?
By nikostis69 in forum Metalworking- / Woodworking Tooling / Manual MachiningReplies: 4Last Post: 01-13-2011, 12:05 AM -
Which router bits/endmills to get??
By margni74 in forum DIY CNC Router Table MachinesReplies: 1Last Post: 09-05-2009, 03:51 AM -
Router bits, End mills v bits
By bogger44 in forum Commercial CNC Wood RoutersReplies: 3Last Post: 12-03-2008, 07:06 PM -
Endmills and Router Bits, Oh My!
By Cartierusm in forum DIY CNC Router Table MachinesReplies: 10Last Post: 11-10-2007, 07:55 AM -
1mm endmills/bits
By johnm99 in forum CNC ToolingReplies: 10Last Post: 09-17-2007, 06:24 PM
Tags for this Thread
Posting Permissions
